Description

Specifications instruction manual FAQ

Sensored brushless power with built-in Bluetooth

The Hobbywing EZRUN MAX10 G2S combo pairs an 80A sensored ESC with a 3652SD G3 4100KV motor for smooth acceleration and responsive throttle control in 1/10 scale RC cars. Its built-in Bluetooth makes setup and data review convenient through the HW LINK smartphone app.

Key features

  • Bluetooth integrated into the power switch for settings, data review and firmware updates without an extra module.
  • Internal logging records the last 10 minutes of running data.
  • Sensored brushless operation delivers smooth starts and linear power delivery.
  • Adjustable Turbo timing up to 20 degrees with the matched motor.
  • Switch-mode BEC with 6V, 7.4V and 8.4V settings for standard and high-voltage servos.
  • Temperature-controlled frameless cooling fan and aluminium motor housing.
  • Waterproof sensor connection and sealed construction for outdoor driving.
  • Low-voltage, overheating and signal-loss protection.

What is included?

  • EZRUN MAX10 G2S 80A ESC with XT60 battery connector.
  • EZRUN 3652SD G3 4100KV sensored brushless motor.
  • Supporting installation accessories, including double-sided mounting tape.

Compatibility

Designed for 1/10 on-road cars, buggies, rally cars and lightweight short-course trucks using 2S–3S LiPo batteries. The motor has a 3.175mm shaft and measures 37mm in diameter by 53mm long. A vehicle, suitable battery and charger are required separately.

Installation and setup

  1. Connect the ESC motor wires A, B and C to the corresponding motor connections, then attach the sensor cable using the alignment arrows.
  2. Connect the ESC throttle lead to the receiver throttle channel and connect the battery with correct polarity.
  3. Calibrate the neutral, full-throttle and full-brake positions before first use or after changing the radio system.
  4. Use the HW LINK app to configure the ESC. Choose a BEC voltage supported by the receiver and servo; use 3S LiPo for stable 7.4V or 8.4V BEC operation.

For a sensored installation, change motor direction through the Motor Rotation setting rather than swapping motor wires. Full calibration steps are provided in the instruction manual.

Read More...



In Stock
Stock Location